Creating a Flip Polyline Direction command toolbar button

This command was written by a user of Autodesk products, not Autodesk Inc. Therefore, the end user is responsible for any problems that may arise due to the installation and use of it.

This command changes the reverses the orientation point of a polyline that has been drawn for the purpose of defining an alignment.

Download the file below to the directory shown. The path shown may vary depending on the version of Land Desktop you are operating.

Save this file to c:\program files\land desktop 3\support.

flip_poly.bmp (BMP; 1 KB)

Highlight the following code and copy it to the Windows clipboard using the right click/copy function of your mouse.

^C^C_explode;\;^C^C^C^P(cr_mnl)(zz_sdsk'(command^M;"_aec_civil_flipbearing"));sdsk;l;;pedit;l;y;J;ALL;;X;CHANGE
;L;;P;C;150;;DELAY;2000;CHANGE;P;;P;C;BYLAYER;;pedit;l;lt;on;;

The Adobe Acrobat document below provides instructions for creating the toolbar button.

This document requires Adobe Reader.

Creating a Flip Polyline Direction command toolbar button (PDF; 14 KB)

If you have a program setting or customization that you would like to share with other users via this Web site, you may contact Gary Vandawalker.

Contact Information

You may send comments regarding this Web site to:

State Conservation Engineer

Peter E. Wright
Syracuse, New York
Telephone: 315-477-6538

If you encounter any problems with this page, have questions, suggestions, or find a broken link, please contact Gary Vandawalker at 315-477-6546.

You may send comments regarding this Web site to:

State Conservation Engineer

Peter E. Wright
Syracuse, New York
Telephone: 315-477-6538

If you encounter any problems with files provided on this page, have questions, suggestions, or find a broken link, please contact Gary Vandawalker at 315-477-6546.

Back to Top

< Back to Program Settings and Customization - Custom Commands and Toolbar Buttons