Creating a Continuous Distance command toolbar button

This command was written by a user of Autodesk products, not Autodesk Inc. Therefore, the end user is responsible for any problems that may arise due to the installation and use of it.

The command allows for continuous distance measurements with an entity selection option and a total of all measurements made.

Download the files below to the directories shown. The paths assume the user is operating Autodesk Land Desktop 3. Your directory structure may vary depending on the Autodesk version you are operating.

The Adobe Acrobat document provides instructions for creating the toolbar button and using the command.

Save this file to c:\program files\land desktop 3\support. Applies to Land Desktop 3 only. New releases of Autodesk products require a different location.

cdist.bmp (BMP; 1 KB)

Save this file to c:\program files\land desktop 3\land.

cdist.lsp (LSP; 11 KB)

This document requires Adobe Reader.

Creating a Continuous Distance command toolbar button (PDF; 14 KB)

If you have a program setting or customization that you would like to share with other users via this Web site, you may contact Gary Vandawalker.

Contact Information

You may send comments regarding this Web site to:

State Conservation Engineer

Peter E. Wright
Syracuse, New York
Telephone: 315-477-6538

If you encounter any problems with files provided on this page, have questions, suggestions, or find a broken link, please contact Gary Vandawalker at 315-477-6546.

Back to Top

< Back to Program Settings and Customization - Custom Commands and Toolbar Buttons